Expert Answers about Newmar Canyon Star Motorhome

• Seat Cover For RV Captains Seats in a 2013 Newmar Canyon Star Motorhome
• At this time the Classic Accessories RV Captain Seat Cover # CA80112 is the only seat cover we carry. This cover is designed to fit seats 23-1/2" wide with backs up to 23-1/2" tall and arm rests 17" long. You will need to measure your seats to verify if they will fit.
  view full answer...


• Recommended Jack Foot Pads For A 2016 Newmar Canyon Star 3710
• For 10" octagon shaped jack feet you would need the SnapPad EQ Octagon Jack Pads # SN76FR that you were already looking at, but before purchasing you'll need to measure just how tall the edges stick up from the ground since your jack feet curl up. The pads that we offer only have a gap large enough to handle 1/4". If the edges raise higher than 1/4" then you wouldn't be able to use SnapPads and would need to use the Stromberg Carlson RV Jack Pads for Equalizer Systems - 10" Round or Octagonal...
  view full answer...


• Replacement For Dometic Air Conditioner For RV
• You can replace your Dometic AC units and won't need a new thermostat to do so, though you may need an adapter, the Adapter Wiring Kit for Advent Air RV Air Conditioners - 9-Pin to 6-Pin # ACCOLKIT. We don't have a way to look this up, but you can check this by removing the cover on the air distribution box inside your RV to see the controller where the wiring runs. The harness for your existing unit will hang down and plug into the controller, and will be either the 6- or 9-pin connector...
  view full answer...


• Correct Snap Pads for Newmar Canyon Star Motorhome
• I recommend measuring the feet on your leveling system and noting the shape of the pad. That said, it should be 9" round pads and in which case you would use the SnapPad XTRA Jack Pads for Lippert Leveling Systems part # SP54FR4. If you have a different size/shape you can select this from the list below.
  view full answer...


• Bike Rack Compatibility with Motorhome While Flat Towing a 2015 Kia Soul
• The Swagman Dispatch 2 Bike Platform Rack - 2" Hitches - Frame Mount # S44FR will be about 33 inches from the hitch pin hole to the farthest point of the rack. You will need to measure your tow bar to see how much actual clearance that will give you for turning clearance. This rack does have a shank rise of 6-1/4 inches, so that will possibly help with hood clearance as well. I recommend using a shank like the Replacement Shank for Gen-Y Adjustable Ball Mount - 2" Hitch - 10" Drop/Rise...
  view full answer...